Permatex High Strength Threadlocker RED Gel Squeeze

  • Sale
  • $23.98
  • Regular price $37.13


High Strength Threadlocker RED Gel Squeeze

OEM specified. Gel formula provides “liquid-reliability” without drips, globs, mess or waste. Available in three convenient sizes, the GEL TWIST pin-point applicator, the GEL SQUEEZE applicator, or the single-use pouch puts the Threadlocker right where you want it…on the part! High strength threadlocker for heavy-duty applications 3/8 inch to 1 inch (10mm to 25mm). Especially well-suited for permanently locking studs & press fits. Adds 3,000 PSI holding power on slip & press fit assemblies. Replaces set screws & snap rings. Locks against vibration loosening. May require heat or special tools for removal. Conforms to ASTM D5363 AN0221 (Mil-S-46163A, Type I, Grade K).

Applications:

    - Automobile - Suggested Applications: Cylinder block & rocker arm studs, ring gear bolts, frame bolts, shock absorber bolts; also ideal for vertical applications- Heavy Duty - Suggested Applications: Cap screws & mounting studs on differentials

Directions:

Parts should be clean & oil free.

    - Remove protective cap.- Turn dial to expose 1/8″ to 1/4″ of material beyond tip.- Apply threadlocker to leading edge of male fitting,covering 5 to 6 threads. Avoid direct contact of tip to metal surface*.- Assemble parts & tighten to recommended torque.- Replace protective cap.*If contact occurs, expose 1/16” of material & wipe off with a clean towel.Temperature range: -65°F to 300°F (-54°C to 150°C).Refer to Technical Data Sheet for complete information.

NOTE: Permatex Threadlocker Gel should not be used on plastic fittings. Do not use on food contact surfaces.Avoid food contamination during use & storage.